Breadboard Jumper Cable Wires (Red and Black) - 20 Units

A set of 20 male-to-male breadboard jumper wires in red and black, each 20 cm long. Designed for quick, reusable connections on standard 0.1" breadboards and prototype boards. The color coding helps keep power (red) and ground (black) neatly organized during circuit building.

Key Specifications

What You Can Build With This

• Arduino sensor and actuator connections on a breadboard
• Raspberry Pi GPIO prototyping with external components
• Power distribution rails for multiple LEDs and switches
• Temporary test circuits before soldering on perfboard

Compatibility

These male-to-male jumpers plug directly into breadboards, Arduino Uno, Mega, Nano, Raspberry Pi 40-pin headers, ESP8266, ESP32, and any board with a 2.54 mm pin pitch. They handle low-voltage DC signals up to 1A comfortably; do not use for mains voltage.

Wiring Notes

Insert the pin ends firmly into breadboard tie points or female headers. The 24 AWG wire is flexible and rated for about 1A continuous current. Use red for positive power lines and black for ground to reduce wiring errors. Avoid sharp bends near the connector to prevent metal fatigue.

Why Buy from Compoden

Every component is sourced from verified suppliers and tested for compatibility before listing. We've spent 10 years building projects for makers, schools, and institutions across India. Ships from Bengaluru in 3-5 days. If defective on arrival, replace within 7 days.